View DPG47BB400_4525955.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

CAPACITORS
Long-life grade (up to 2000 hours @ 105C) Standard snap-in pin style Case size options The DPG is a snap-in electrolytic capacitor featuring a higher degree of volumetric efficiency than previous types. The product is particularly suited for the high-voltage end of switching power supplies. The high ripple current capability is very useful in motor-drive applications.
ALUMINIUM ELECTROLYTIC HIGH TEMP. SNAP-IN DPG
SECTION 1
SPECIFICATION
Item Operating Temperature Range Rate Working Voltage Range Capacitance Tolerance DC Current Leakage (A) Electrical Characteristics -40 to +105C -25 to +105C 6.3 to 100VDC 160 to 450VDC 20% (At 20C, 120Hz)
I = 0.02 CV, L= 20m/m, l= 0.03mA Whichever is smaller. (At 25C, After 5 Minutes) Where, l: Leakage Current (A) C: Nominal Capacitance (F) V: Rated Voltage (V) Dissipation Factor (tand) Rate Voltage (V) 6.3 10 16 25 D.F (%) 60 55 50 45 * Note: 15% For D = 35m/m or L = 20m/m (At 20C, 120Hz) (WV = 6.3 to 100V For capacitor whose capacitance exceeds 1000F The value of D.F (%) is increased by 2% for every addition of 1000F Low Temperature Characteristics (120Hz) Rated Voltage (V) Z(-25C) / (Z+20C) Z(-40C) / (Z+20C) Load Life 6.3-16 4 15 25 3 10 35 3 8
35 35
50 30
63-100 30
160-450 15
50-63 80-100 160-400 2 6 2 5 4 -
450 8 -
The following specifications shall be satisfied when the capacitors are restored to 20C after the rated voltage with maximum ripple current is applied for 2000 hours at 105C. Capacitance Change D.F Leakage Current 20% of the initial value 200% of the initial specified value the initial specified value
Shelf Life
The following specifications shall be satisfied when the capacitors are restored to 25C after exposing them for 1000 hours at 105C without voltage applied. Capacitance Change D.F Leakage Current 20% of the initial value 150% of the initial specified value 150% of the initial specified value
ORDERING INFORMATION DPG
Range
7
Capacitance f Height A = 20mm B = 25mm C = 30mm D = 35mm E = 40mm F = 45mm G = 50mm
AC
Case Code (see below)
00
Voltage
Two letter case code AC = 22.4mm dia. x 30mm height. Diameter A = 22.4mm B = 25mm C = 30mm D = 35.5mm
Fax: 01371 875075
www.dubilier.co.uk
Tel: 01371 875758
CAPACITORS
ALUMINIUM ELECTROLYTIC HIGH TEMP. SNAP-IN DPG
RIPPLE CURRENT MULTIPLIERS
1) Maximum rms ripple currents at 120Hz, 85C and 105C are given in the table. 2) Temperature multiplying factor; Where capacitors are operated at temperature other than 105C, the maximum ripple current must be multiplied by the figure shown in the table below. 3) Frequency multiplying factor; If capacitors are used to filter circuits at a frequency other than 120Hz, the rated 120Hz rms ripple current shown must be multiplied by the factor shown in the table below.
SECTION 1
AMBIENT TEMP./MULTIPLYING FACTOR
Temperature coefficient Temperature ( C ) Factor 60 2.37 70 2.17 85 1.67 105 1.00
FREQUENCY/MULTIPLYING FACTOR
Frequency coefficient Freq(Hz)/Cap(uF) 6.3 to 100V 160 to 250V 315 to 450V 50 0.88 0.85 0.88 0 0.90 0.88 0.9 10 1.00 1.00 1.00 1K 1.15 1.15 1.10 10K - 00K 1.16 1.20 1.15
OUTLINE DRAWING
0.9 +0.2/-0.1 Vinyl Sleeve Negative 0.8 0.1
10 0 .1
6.0 1 3.5
Safety Vent L 2 6 1 D 1 D 1 Mounting Holes on Chassis
1.5 0.1 Terminals
70
Fax: 01371 875075
www.dubilier.co.uk
Tel: 01371 875758
CAPACITORS
W.V. Cap [F] 6800 10000 15000 22000 10V 33000 47000 68000 6800 10000 15000 25x45 30x35 35.5x30 30x45 35x35 35.5x50 22.4x25 22.4x30 25x25 22.4x40 25x35 30x30 25x45 30x35 30x45 35.5x35 35.5x45 22.4x25 25x30 30x25 25x25 22.4x40 25x35 30x30 25x45 30x35 35.5x30 30x45 Case Size 35.5x35 oDxL[mm] 35.5x50 22.4x35 25x25 22.4x40 25x35 30x30 25x45 30x35 35.5x30 30x45 35.5x35 35.5x50 22.4x30 24.4x35 25x30 3.3 3.8 5.5 1.55 1.95 2.55 Case Size oDxL[mm] 25x25 20x30 25x25 25x30 Max Ripple Current [A] rms (10Hz/105C) 1.30 1.84 1.90 2.25
ALUMINIUM ELECTROLYTIC HIGH TEMP. SNAP-IN DPG
SECTION 1
16V
22000 33000
3.3 4.30
47000
5.4
4700 6800 25V 10000
1.79 1.85 2.40
15000 W.V. 22000 Cap [F] 33000 4700
3.15 3.75 Max Ripple Current [A] rms 5.40 (10Hz/105C) 1.80
6800 35V 10000 15000 22000 2200 3300
2.70
3.30 3.91 4.59 1.55 1.87
50V
71
Fax: 01371 875075
www.dubilier.co.uk
Tel: 01371 875758
CAPACITORS
ALUMINIUM ELECTROLYTIC HIGH TEMP. SNAP-IN DPG
SECTION 1
W.V.
Cap [F]
Case Size oDxL[mm] 22.4x45 25x40 30x30 35.5x25 25x50 30x40 35.5x30 30x50 35.5x40 35.5x50 20x25 22.4x30 25x25 22.4x35 25x30 22.4x50 25x40 30x30 35.5x25 25x50 30x40 35.5x30 30x50 35.5x40 35.5x50 22.4x30 25x25 22.4x35 25x30 22.4x45 25x35 30x30 35.5x25 25x50 30x40 35.5x30 30x50 35.5x40 35.5x50 24.4x25 24.4x35 25x30
Max Ripple Current [A] rms (10Hz/105C)
W.V.
Cap [F]
Case Size oDxL[mm] 22.4x45 25x40 30x30 35.5x25 25x50 30x40 35.5x30 30x50 35.5x40 35.5x50 22.4x25 24.4x25 22.4x35 22.4x45 25x35 25x45 30x35 30x45 35.5x35 35.5x50 22.4x25 22.4x30 25x25 22.4x35 25x35 25x30 25x40 30x30 30x45 35.5x35 35.5x50 22.4x30 25x25
Max Ripple Current [A] rms (10Hz/105C)
W.V.
Cap [F] 330
Case Size oDxL[mm] 22.4x40 30x25 30x30 35.5x35 35.5x40 22.4x30 22x25 22.4x35 25x30 25x45 30x35 35.5x30 30x45 35.5x40 35x40
Max Ripple Current [A] rms (10Hz/105C) 1.21 1.52 1.92 2.3 0.35 0.49 0.62
4700
2.25 100V 3.25 4.00 4.77 1.10 1.30 1.70 160V
1500
1.95
250V
50V
6800 10000 15000 1000 1500 2200
2200 3300 4700 220 330 470 680 1000
2.53 400V 3.25 4.53 0.66 1.20 1.28 1.64 2.17 2.62 3.34 0.78 1.20
470 680 1000 47 68 100
220 330 470
1.00 1.40 1.75
63V 3300
2.10
1500 2200
4700 6800 10000 1000 1500
2.80 3.65 4.40 1.20 1.45 200V
220 330
470 680 1000 1500 220
1.40 1.75 2.30 2.21 0.97
250V 2.00
80V
2200
3300 4700 6800 680 1000
2.40 3.30 4.72 1.04 1.43
100V
7
Fax: 01371 875075
www.dubilier.co.uk
Tel: 01371 875758

▲Up To Search▲

Price & Availability of DPG47BB400

	To Download DPG47BB400 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .